EpoxyPRO Oil Stop Primer is used prior to finish coating your floor. It is a two component industrial grade epoxy undercoating engineered specifically to cover oil, petroleum, and silicone based contamination that cannot be removed with a degreaser. In many instances petroleum and silicone based products can penetrate the surface of concrete floors to the extent that the oil may not be removed by surface cleaning. If untreated, this oil may migrate back to the surface to cause a delamination. Our Oil Stop primer mixes with these contaminates and penetrates deeply into the concrete substrate to lock in contamination, leaving a more receptive concrete surface and though it exhibits excellent characteristics for coating over petroleum based oil contaminated concrete this product however, is not intended for use over vegetable oil, animal fat or synthetic oil contaminated concrete.
COVERAGE: (1A to 1B mix ratio up to 300 SF per gallon)
RECOMMENDED FOR: Recommended for petroleum oil contaminated substrates. This product can withstand exposure to many common solvents and chemicals and allows excellent substrate penetration which results in excellent adhesion and is an ideal primer for the oil contaminated concrete substrate.
EpoxyPRO Oil Stop Primer is suited as a primer for most epoxy-based products where petroleum oil based contamination cannot be fully removed using degreasers or floor etching solutions. These applications include the following:
|Chemical Storage Areas
||Chemical Processing Areas
||Fork Lift Areas
||Health Care Facilities
||Law Enforcement Facilities
|Meat Preparation Areas
||Nuclear Plant Floors
||Oil Storage and Processing Facilities
|Photography Processing Areas
|Produce Preparation Areas
|Secondary Containment Structures
ADVANTAGES of EpoxyPRO Oil Stop Primer:
– Provides for proper bond adhesion for petroleum based oil stains
– Preserves concrete
Concrete should be thoroughly degreased and solvent washed to remove as much oil as possible.
Temperature of concrete must be 60°F or above at time of mixing. Stir each component separately before blending. Pour Part A into a clean container and add Part B Stir for three minutes with a low speed electric drill motor equipped with a mixing paddle. Immediately begin application.
RECOMMENDED FILM THICKNESS: 5-8 mils per coat wet thickness = 3-5 mils dry. COVERAGE: 200-320 square feet @ 5-8 mils wet thickness. Apply with brush, or 3/8″ nap roller.
EpoxyPRO Oil Stop Primer for oil saturated concrete – will normally be ready to recoat in 8-10 hours. Top-coating before 8 hours can cause some slight bleeding of the Oil Stop Primer into the topcoat. For best results wait 16-24 hours before applying the EpoxyPRO Industrial Grade Epoxy Floor Coating of your choice.
Prolonged or repeated exposure may cause eye and skin irritation. If contact occurs, wash immediately and seek medical help. Use safety glasses with side shields and wear protective rubber gloves.
Proper mixing and installation is critical to the optimal success of all products. See Articles and Resources at EpoxyPro.com for more details on our products. Be sure to contact us with any questions and/or concerns that you have at firstname.lastname@example.org or calling 877-70-EPOXY (32699)